🔖 Cable-tie binding
The coil is bound with a plastic tie fed from a tape on a reel.
Samec RV500EF coils flexible cables and tubes and automatically binds the coils with plastic cable ties. The coil is formed on a rotating pin plate under a Plexiglas guard. When finished, the guard lifts by itself and the pins retract into the base, so the coil is easy to remove. The electronics match the coiling speed to the machine, and operating modes are set on a 7-inch touchscreen.
Pin plate and coil being wound
Reel of cable-tie tape
Cable coil bound with a tie
7-inch touchscreen for setting operating modes
The coil is bound with a plastic tie fed from a tape on a reel.
Inner diameter from 110 mm, outer up to 450 mm, cables up to Ø 16 mm.
After the cycle the coil is easy to remove, and the next cycle starts with the foot pedal.
Settings, operating modes and diagnostics on the touchscreen.
| Data input | 7-inch touchscreen |
|---|---|
| Program memory | max. 300 |
| Coiled piece length | Depends on cable diameter |
| Coiled cable diameter | max. Ø 16 mm (depending on flexibility) |
| Coil inner diameter | min. 110 mm |
| Coil outer diameter | max. 450 mm |
| Coiling speed | max. 2.5 m/s |
| Electrical supply | 230 V – 50/60 Hz – 6 A |
| Pneumatic supply | 6 bar, continuous operation |
| Dimensions and weight | 850 × 1640 × H 1980 mm • 185 kg |
When your customer requires coils bound with cable ties and fitting them by hand slows the line down. The RV500EF handles smaller coils (from Ø 110 mm) and cables up to Ø 16 mm. If binding with an elastic tie is enough, see the RV500EL.
Plastic cable ties fed from a tape on a reel.
Coils with an inner diameter from 110 mm and an outer diameter up to 450 mm, from cables and tubes up to Ø 16 mm (depending on flexibility).
Yes, once fitted with the encoder unit with external sensors. As standard, the coiler has a connector for Samec machines.