🔁 Two plates, less downtime
One coil winds while you remove the other.
Samec RV350D has two rotating plates with pins under a Plexiglas guard. When coiling is finished, the operator presses the pedal, the guard slides over the second plate, the pins rise and the next coil starts. Meanwhile, the operator removes the finished coil from the first plate, which must be empty before the next press of the pedal. The electronics match the coiling speed to the set coil diameter and the machine speed.
Two pin plates under a sliding guard
Removing a finished coil from one plate
Conical cable guide bushes
Beckhoff touchscreen for setting operating modes
One coil winds while you remove the other.
Cables and tubes up to Ø 16 mm, depending on flexibility.
Coiling speed matched to the set coil diameter and the machine's operation.
Operating modes, parameters and diagnostics on the touchscreen.
| Data input | 7-inch touchscreen |
|---|---|
| Program memory | max. 300 |
| Number of plates | 2 |
| Coiled piece length | Depends on cable diameter |
| Coiled cable diameter | max. Ø 16 mm (depending on flexibility) |
| Coil inner diameter | min. 140 mm |
| Coil outer diameter | max. 350 mm |
| Coiling speed | max. 2.5 m/s |
| Electrical supply | 230 V – 50/60 Hz – 6 A |
| Pneumatic supply | 6 bar, continuous operation |
| Dimensions and weight | 950 × 1050 × H 1200 mm • 200 kg |
When you coil many short pieces into small coils and don't want the machine to wait while a coil is removed. Two plates let you remove a finished coil while the other one is winding. For larger coils (up to Ø 500 mm) there is the RV500.
When coiling is finished, the operator presses the pedal, the guard slides over the second plate and the next coil starts there. The finished coil on the first plate must be removed before the pedal is pressed again.
Coils with an inner diameter from 140 mm and an outer diameter up to 350 mm, from cables and tubes up to Ø 16 mm (depending on flexibility).
Yes, with the optional encoder unit with external sensors.