🌀 Coils Ø 140–500 mm
Coil inner diameter from 140 mm, outer up to 500 mm.
Samec RV500 coils flexible cables and tubes on a rotating pin plate. It works inline with Samec cut-and-strip or cutting machines, and with an additional encoder and sensor also with other manufacturers' machines. The electronics automatically match the coiling speed to the machine speed, and the operator starts the next cycle with a foot pedal. Operating modes and parameters are set on a 7-inch touchscreen, which also shows diagnostics.
Pin plate and cable coil being wound
Lifting Plexiglas guard over the plate
Conical cable guide bush
Foot pedal starting the next cycle
Coil inner diameter from 140 mm, outer up to 500 mm.
The maximum diameter depends on cable flexibility.
The electronics match the coiling speed to the machine speed.
Settings, operating modes and diagnostics on the touchscreen.
| Data input | 7-inch touchscreen |
|---|---|
| Program memory | max. 300 |
| Coiled piece length | Depends on cable diameter |
| Coiled cable diameter | max. Ø 20 mm (depending on flexibility) |
| Coil inner diameter | min. 140 mm |
| Coil outer diameter | max. 500 mm |
| Coiling speed | max. 2.5 m/s |
| Electrical supply | 230 V – 50/60 Hz – 6 A |
| Pneumatic supply | 6 bar, continuous operation |
| Dimensions and weight | 1000 × 500 × H 1100 mm • 180 kg |
When you coil cables and tubes up to Ø 20 mm and the coil does not need to exceed Ø 500 mm. For larger coils (up to Ø 750 mm) and cables up to Ø 32 mm there is the RV800. If the coils need to be bound right away, see the RV500EL (elastic tie) or RV500EF (cable ties).
Flexible cables and tubes up to 20 mm in diameter (depending on flexibility), into coils with an inner diameter from 140 mm and an outer diameter up to 500 mm.
Yes, once fitted with the encoder unit with external sensors. As standard, the coiler has a connector for Samec machines.
Up to 2.5 m/s. The electronics automatically match the coiling speed to the machine's operating speed.